- Stay Soft
The next time you’re cleaning your car pick up some Armor All® Vinyl Protectant. Spray the Armor All
into a soft towel or rag and run it over your car’s speed control, battery, motor, and radio wires. Not
only will your wires be clean; they’ll stay soft and pliable longer.
- Threading Antenna Tubes
If you have trouble putting your antenna through the tube, put some black grease on the entrance of
the tube to lube it.
- Dry Receiver
Put your receiver in a balloon to prevent it getting dirty.
- On-Off Switch
Position the on/off switch so that when the switch is ON, it is towards the back of the car. That way if
a rock or something hits it as your driving, it won’t turn off. Even better is to position it LAYING
DOWN and FACING BACKWARDS in the chassis.
- Spiral Leads
Make your car look like a Factory Car from the inside. Take the wires that go to the receiver and
wrap them around an Allen wrench. This will make a "spiral" and look much neater.
- Excess Antenna Wire?
Have too much antenna wire? Cut a pop-sicle stick and wrap the excess antenna around it before
you put it into the tube.
- Lost Antenna Cap
Lost your antenna tube cap? Put a piece of fuel tubing over the top instead.
- Crystal Storage
Keep your spare crystals safe and organised by storing them in a seven-day pill container, each pair
in a different day.
- Crystal Storage 2
Store spare crystals in old X-Atco blade cases for protection.
